MVSI-ACC with high centrifugal force valuesby ItalvibrasShaft extension type The MVSI-ACC series, deriving directly from the MVSI series, is characterised by the motor shaft projecting from one side, allowing in-line coupling, using a coupling, between two equal vibrators. The MVSI-ACC series is very useful for manufacturers of large screens and vibrating machines, or for plants that require very high centrifugal force values. With two vibrators of the MVSI-ACC series coupled in line, it is possible to arrive at a centrifugal force of 50.000 Kgf (490kN). Upon request, it is possible to supply the shaft extension on both sides of the vibrator, so to enable the connection of three or more vibrators. The "ACC" design can be supplied on request on other motor sizes not listed on the website. Technical features Power Supply Three-phase voltage from 230V to 690V, 50Hz or 60Hz; suitable for use with an inverter from 20Hz to the base frequency, with constant torque load profile. Polarity 6 standard poles, other polarities on request. Conformity with European Directives Low voltage 2006/95/EC. Functioning Continual service (S1) at maximum declared centrifugal force and electric power. Centrifugal force Range extended up to 50000 Kgf. (490 KN) for the couple of vibrators, with centrifugal force adjustable from 0 to 100%. Mechanical protection IP 55 according to IEC 529, EN 60529 Protection against mechanical impacts IK 08 according to IEC 68, EN 50102. Insulation class Class F (155°C), class H (180°C) on request. Tropicalization Standard on all vibrators, with vacuum encapsulation or with "drop by drop" trickle system. Ambient temperature From -20°C to +40°C. Versions for higher or lower temperatures are available on request. Vibrator thermal protection With PTC rated thermistor heat detectors 130°C (DIN 44081-44082). On request, thermistors with different temperatures and anti-condensation heaters. Fixing of the vibrator In all postions and therefore without restriction. Linear coupling using dynamic joint between the two vibrators. Lubrication All vibrators are correctly lubricated in the factory and do not require further lubrication if used in normal operating conditions ("FOR LIFE" lubrication). In heavy duty operating conditions periodical re-lubrication methods may be applied. Terminal box Large fixed electrical connections. Special shaped terminals allow to fix the power supply cable, protecting it from loosening. Electric motor Three-phase asynchronous type. Designed for maximum starting torques and torques curves specific to vibrating machines. Insulated windings using "drop by drop" trickle system with class H resin. The rotor is die cast aluminium. Casing In spheroidal cast iron to guarantee sturdiness and elasticity. Patented shape that improves heat dispersion and lowers normal working temperature at full load. Bearing flange Constructed in spheroidal cast iron. The geometry of the flange transmits the load to the casing uniformly. Bearings Custom made with particular geometry, especially designed for Italvibras, suitable to support both high radial and axial loads. Motor shaft In treated steel alloy (Isothermic hardening) resistant to stress. Projecting from one side to allow linear coupling using a joint. Eccentric weights Allow continual adjustment of the centrigugal force. This adjustment is realized by a graduated scale, which expresses the centrifugal force as a percentage of the maximum centrifugal force. A patented system (patent N°MO98A000194), called ARS, prevents adjustment errors. Weight covers In aluminium alloy, from the shaft extension side the weight cover is sectioned: it is made up from two halves, which guarantee opening even after coupling between the two vibrators. Painting Electrostatic surface treatment based on polymerised epoxy polyester powder in oven at 200°C. Tested in salt spray for 500 hours. Certifications There are many, please contact our office for specifics. Serveral sizes are available with different mounting bolt patterns. Please contact our office at 1-888-558-9956.